Rohn H50 Telescoping Mast

Rohn H50 Telescoping Mast


ROHN H 50 Data Sheet 

ROHN H50 Assembly

ROHN H50 Specs

Available in 20', 30', 40' and 50' heights. All ROHN  Telescoping Masts are pre-galvanized and come assembled with hardware.

Erecting the Telescoping Mast is made by simply connecting guys and brackets to the attached unique heavy duty rolled edge guy rings and clamps, extend the sections, insert the locking cotter pins, rotating the tubes to a locked position, and tightening the clamps.

The unique ROHN Telescoping Mast design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common masts. This exclusive design also prevents the sections from accidentally pulling apart and allows disassembly by pulling each section out through the lower end.

Each section extends deeper in to the lower tubes than most other Telescoping Mast designs, adding still further to the stability of the structure.

H Series

This heavy duty series of Telescoping Masts uses 1-1/4" 16 gauge galvanized tubing for top section. All other sections are 18 gauge.


The ROHN 9H50 Telescoping Mast is pre-galvanized for corrosion protection and comes assembled with hardware. It is meant for use in guyed or bracketed installations. Please note that guys, guy wire, anchors, and base mount are not included. Height refers to overall pipe length. Actual assembled height will be less due to overlapping.

Used for Off-Air TV Antenna, Amateur (Ham) Radio, Wireless Internet Antenna, MMDS and Cell Phone Signal Booster Installations (not included). All Telescoping push-up Masts are galvanized and come with hardware designed to support light duty antennas in various applications. The unique Rohn design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common mast. Each section extends deeper into the lower tubes than most designs, adding to the masts stability. Height describes the overall pipe length. Due to overlapping, extended masts will be shorter. This Mast extends to 43 Feet in actual height that ships to Commercial and Residential addresses alike. Estimated Usable Extended Height is around 43 Feet.

Mast Section Dimensions are:

(1) 10'0"" length x 1.25"" O.D. (16 AWG)

(2) 9'10"" length x 1.50"" O.D. (18 AWG)

(3) 9'04"" length x 1.75"" O.D. (18 AWG)

(4) 8'10"" length x 2.00"" O.D. (18 AWG)

(5) 8'04"" length x 2.25"" O.D. (18 AWG) 

Specifications Rohn H50

Brand ROHN  Manufacturer's Part Number  H50  Part Type Telescoping Masts